HP XC System Software Installation Guide Version 2.1

Creating /opt/hptc/lsf/top ...
... Done checking the LSF TOP directory /opt/hptc/lsf/top ...
You have specified <none> to LSF_LICENSE, lsfinstall will continue
without installing a license.
Checking LSF Administrators ...
LSF administrator(s): "lsfadmin"
Primary LSF administrator: "lsfadmin"
Searching hpc distribution tar files in /opt/hptc/lsf/files
Please wait ...
1) linux2.4-glibc2.3-amd64-slurm
1
Press 1 or Enter to install this host type: Enter
1 The sample command output was obtained from an Opteron-based system.
Thus, the tar file name is linux2.4-glibc2.3-amd64-slurm (the string
amd64 signifies an Opteron- or Xeon -based architecture). When configuring an
Itanium-based system, the string ia64 is included in th e file name in s tead.
13. The rem ainder of the system configuration output looks similar to the following. This
sample output is provided for your info rm ation only so you can follow along with your
own configuration processing; there is nothing else you have to do in this step. Despite
some of th e messages shown in the c o m m a nd outpu t, eve ry thi ng you need to install,
configure, and verify SLURM and LSF HPC is documented in this manual.
You have chosen the following tar file(s):
hpc6.0_linux2.4-glibc2.3-amd64-slurm
Checking selected tar file(s) ...
... Done checking selected tar file(s).
Pre-installation check report saved as text file:
/opt/hptc/lsf/files/tmp/hpc6.0_hpcinstall/prechk.rpt.
... Done LSF pre-installation check.
Installing hpc binary files " hpc6.0_linux2.4-glibc2.3-amd64-slurm"...
Creating /opt/hptc/lsf/top/6.0 ...
Copying hpcinstall files to /opt/hptc/lsf/top/6.0/install
Creating /opt/hptc/lsf/top/6.0/install ...
Creating /opt/hptc/lsf/top/6.0/install/instlib ...
... Done copying hpcinstall files to /opt/hptc/lsf/top/6.0/install
Installing linux2.4-glibc2.3-amd64-slurm ...
Please wait, extracting hpc6.0_linux2.4-glibc2.3-amd64-slurm may take up to a few
minutes ...
... Done extracting /opt/hptc/lsf/files/hpc6.0_linux2.4-glibc2.3-amd64-slurm.tar.Z.
Creating links to LSF commands ...
... Done creating links to LSF commands ...
Modifying owner, access mode, setuid flag of LSF binary files ...
... Done modifying owner, access mode, setuid flag of LSF binary files ...
Creating the script file lsf_daemons ...
... Done creating the script file lsf_daemons ...
... linux2.4-glibc2.3-amd64-slurm installed successfully under
/opt/hptc/lsf/top/6.0.
... Done installing hpc binary files "linux2.4-glibc2.3-amd64-slurm".
Creating LSF configuration directories and files ...
Creating /opt/hptc/lsf/top/work ...
Creating /opt/hptc/lsf/top/log ...
Creating /opt/hptc/lsf/top/conf ...
Creating /opt/hptc/lsf/top/conf/lsbatch ...
Configuring and Imaging the System 4-19