HP XC System Software Installation Guide Version 2.1

Discovering Console Ports...
running port_discover on 172.20.65.2
running port_discover on 172.20.65.2
Discovering 172.20.65.2 port 42 ... Console Port OK
Discovering 172.20.65.2 port 41 ... Console Port OK
Discovering 172.20.65.2 port 40 ... Console Port OK
Restarting dhcpd
discovered_cps is 3
Checking if all console ports are reachable ...
number of cps to check, 3
pinging 172.21.0.14
pinging 172.21.0.16
pinging 172.21.0.15 .done
Opening /etc/hosts
Opening /etc/hosts.new.XC
Opening /etc/powerd.conf
Building /etc/powerd.conf ... Querying cp-n14
Querying cp-n15
Querying cp-n16
done
_____________________ Important _____________________
This note applies only to X C systems with nodes that u se Integrated Lights
Out (iLO) as the console management device.
If the discover process hangs when it tries to discover t he console ports, it
may be because the iLO console management devices do not have telnet
enabled. See Appendix F, which describes how to enable telnet on iLO
devices.
Attempting to start hpls power daemon ... done
Attempting to power on nodes with nodestring n[14-15]
Powering on all known nodes ... done
Discovering Nodes...
running port_discover on 172.20.65.1
nodes Found = 1 nodes Expected = 3
running port_discover on 172.20.65.1
nodes Found = 1 nodes Expected = 3
running port_discover on 172.20.65.1
nodes Found = 3 nodes Expected = 3
All nodes initialized.
Powering off all nodes but head node ... done
Switch 172.20.65.1 port 22 ... Node Found
Switch 172.20.65.1 port 21 ... Node Found
Switch 172.20.65.1 port 20 ... Node Found
Switch 172.20.65.1 port 19 ... NO Node Found
4
Restarting dhcpd
node n15 set to model ProLiant DL145 G1
node n14 set to model ProLiant DL145 G1
node n16 set to model ProLiant DL145 G1
Opening /etc/hosts
Opening /etc/hosts.new.XC
1 Enter th e MAC address of the switch that is connected to the admin ports. Do not
enter the MAC address of the switch con nected to the console ports.
4-8 Configuring and Imaging the System