HP XC System Software Hardware Preparation Guide Version 2.1

c. C hoose the Select Active Standard Error Devices option from the
Boot Option Maintenance Menu to enable console m essages to be displayed
on the screen when you turn on the system.
i. Enable the Acpi(HWP0002,700)/Pci(1|1)/Uart(9600
N81)/VenMsg(Vt100+) option.
ii. Enable the Acpi(HWP0002,700)/Pci(2|0) option.
iii. Save the setting to the NVRAM.
iv. Choose Exit to return to the Boot Option Maintenance Menu.
d. Choose the Cold Reset menu option to apply changes.
15. Turn off power to the node:
a. Press Ctrl/b to exit console mode.
b. Enter CM to display the Command Menu.
c. Enter PC to turn off power to the node.
3-16 Preparing Individual Nodes