HP XC System Software Hardware Preparation Guide Version 2.1

Figure 3-6: HP ProLiant DL385 Ser ve r
3
1
2
HPTC-0145
3
133
MHz
1
100
MHz
2
100
MHz
The callouts on the figure enumerate t he following:
1 If a Gigabit Ethernet (GigE) interconnect is configured , this port, labeled 2,isusedforthe
interconnect connection. Otherwise, it is used for an external connection.
2 The port labeled 1 is the connection to the Administration Switch (branch or root).
3 The port labeled iLO is the E thernet connection to the Console Switch.
Figure 3-7 shows the back of the HP P roLiant DL585 serv er.
Figure 3-7: HP ProLiant DL585 Ser ve r
!
1
2
133MHz
12345678
PCI-X
64-Bit
100MHz
12
iLO
2
1
UID
!"#
The callouts on the figure enumerate t he following:
1 The iLO Eth ernet port is the connection t o the Console Switch.
2 If a Gigabit Ethernet (GigE) interconnect is configured , this port is used for the
interconnect connection. Otherwise, it is used for an external connection.
3 NIC1 is the connection to th e A dm inistration Switch (branch or root).
Perform the following hardware preparation t asks from the iLO Setup Utility for each HP
ProLiant DL385 and HP ProLiant DL585 node in your XC system :
1. Turn on power to the node. Watch the screen carefully dur ing the power-on self-test, and
press the F8 key when prompted to access the Integrated Lights Out Setup
Utility.
Preparing Indivi dual Nodes 3-11