6.2 HP IBRIX 9300/9320 Storage Administrator Guide (AW549-96049, December 2012)

• Sender Domain. The domain name that is joined with an @ symbol to the sender name to
form the “from” address for remote notification. The domain name can have a maximum of
31 bytes. Because this name is used as part of an email address, do not include spaces. For
example: MyDomain.com. If the domain name is not valid, some email servers will not process
the mail.
• Email Address fields. Up to four email addresses that the system should send notifications to.
Email addresses must use the format user-name@domain-name. Each email address can
have a maximum of 79 bytes. For example: [e-mail].
In the SNMP Configuration section, set the options:
• Notification Level. Select the minimum severity for which the system should send notifications:
Critical (only); Error (and Critical); Warning (and Error and Critical); Informational (all). The
default is none, which disables SNMP notification.
• Read Community. The SNMP read password for your network. This password is also included
in traps that are sent. The value is case sensitive; can include letters, numbers, hyphens, and
underscores; and can have a maximum of 31 bytes. The default is public.
• Write Community. The SNMP write password for your network. The value is case sensitive;
can include letters, numbers, hyphens, and underscores; and can have a maximum of 31
bytes. The default is private.
• Trap Host Address fields. The IP addresses of up to three host systems that are configured to
receive SNMP traps.
See the MSA array documentation for additional information. For HP P2000 G3 MSA systems,
see the HP P2000 G3 MSA System SMU Reference Guide. For P2000 G2 MSA systems, see the
HP 2000 G2 Modular Smart Array Reference Guide. To locate these documents, go to http://
www.hp.com/support/manuals. On the Manuals page, select storage >Disk Storage Systems >
P2000/MSA Disk Arrays >HP 2000sa G2 Modular Smart Array or HP P2000 G3 MSA Array
Systems.
58 Configuring cluster event notification