HP StoreEasy 3000 Storage Administrator Guide

StatusDescriptionItem
Flashing Green = System is waiting to power on; Power
On/Standby button is pressed.
Solid Amber = System is in standby; Power On/Standby Button
service is initialized.
Off and the Health Status LED bar is off = The system has no
power.
Off and the Health Status LED bar is flashing green = The Power
On/Standby Button service is being initialized.
Solid Blue = IdentifiedUID LED3
Flashing Blue = Active remote management
Off = No active remote management
Green = Network linkedFlexibleLOM LED4
Flashing Green = Network activity
Off = No link or activity
NOTE: For more troubleshooting steps, refer to the platform hardware information. The following
list identifies the ProLiant model for each HP StoreEasy 3000 Storage:
• 3840 Gateway Storage: ProLiant DL380p Gen8
• 3840 Gateway Storage Blade: ProLiant BL460c Gen8
The ProLiant documentation is available at:
http://www.hp.com/go/proliantgen8/docs
Drive LED definitions
The following figure shows the drive LEDs. These LEDs are located on all HP ProLiant hot plug hard
drives.
Figure 7 Drive LEDs
DefinitionStatusLEDItem
The drive is being identified by a host application.Solid blueLocate1
The drive carrier firmware is being updated or requires an
update.
Flashing blue
Drive activityRotating greenActivity ring2
No drive activityOff
Do not remove the drive. Removing the drive causes one or
more of the logical drives to fail.
Solid whiteDo not remove3
12 HP StoreEasy 3000 Storage