User Manual

Adding the printer to an existing wireless network10
The IP Address Setting screen will be displayed.
8. Set the IP Address.
•Select Obtain IP Address automatically if your LAN has a DHCP Server, otherwise select Use following IP
address.
•If you click Use the following IP address, enter an unused address from the address pools used in your LAN.
Use the same IP Subnet Mask and Default Gateway for the Printer Adapter and the PC.
IMPORTANT: Make sure the IP address you choose is not used by any other device on your network.
The Confirmation screen will be displayed.
9. After reviewing the settings, click Apply then click Finish.
Configure other computers to use the printer
To allow the other computers on the network to print to the upgraded printer follow these steps.
NOTE: You do not need the PC adapter. Leave it attached to the first computer.
NOTE: The computer with the PC adapter must be turned on to print to the wireless printer.
1. If you have never installed the printer on the computer, you must install it using a USB cable and the CD that
came with it or a downloaded driver the HP website.
IMPORTANT: If the printer was installed using driver that you pulled over the network, you must reinstall the
printer with the CD or full driver. A network install uses a “mini” driver that is insufficient for wireless
printing.
2. Insert the Wireless Printing Upgrade Kit CD and follow the instructions on the screen.
3. A screen will display and ask you to choose the printer that it has found on the network. Select the printer and
continue.
4. Follow these steps for each computer on your network.