Installing and Configuring HP WebQoS Peak on Linux

Chapter 3 27
HP WebQoS Peak on Linux for the Apache Web Server
Configuring WebQoS Peak on Linux for Apache
isolation is turned on with the HPACVHostIsolation directive. The
default for this directive is “off.” For example, to turn on virtual host
isolation, use the following directive in your configuration file:
HPACVHostIsolation on
With this option in effect, WebQoS Peak raises the priority of new
sessions for those virtual hosts that contribute less than their assigned
share to the system load.
Global Parameters
Most WebQoS Peak configuration directives set values for parameters
that affect individual virtual hosts. A few of them set values for
parameters that affect all virtual hosts. These directives are shown
below. The directives setting global WebQoS parameters should be used
outside virtual host configuration blocks. Inside virtual host
configuration blocks, the directives are ignored and the parameters they
try to set revert to default values.
HPACAdmitPriorityThreshold HPACStatsLogfile
HPACIsolateDamping HPACStatsLogging
HPACLoadDamping HPACVHostIsolation
HPACLogUpdateInterval