HP WebQos Peak for Solaris® Concepts and Operation Guide

32 Chapter3

Conﬁguring HP WebQoS Peak

Starting HP WebQoS

HP WebQoS is enabled after you have run the setup script (see “Running

the Setup Script” on page 16 for more information).

If you have stopped HP WebQoS, then you can start it again by

conﬁguring and specifying the load from the HP WebQoS Peak Session

Settings administration web page.

Re-Enabling the HP WebQoS Peak Session

Settings Page

To re-enable the HP WebQoS Peak Session Settings administration

web page, do the following:

1. Edit the /

server_root

/config/hpac/config.ac ﬁle and remove the

conﬁguration parameter gui.disable.

2. Restart the web server.

Stopping HP WebQoS

To stop or disable HP WebQoS, select “Always admit” in the Admission

section of the HP WebQoS Peak Session Settings administration web

page.

If you are permanently stopping HP WebQoS, you should remove HP

WebQoS from your system (see “Removing HP WebQoS” for more

information). Because HP WebQoS does not cache HTML, performance

may be slow for static pages.