HP WebQos Peak for Solaris® Concepts and Operation Guide

Chapter 3 21
Configuring HP WebQoS Peak
Configuring HP WebQoS
2. If idle is greater than zero, then set the threshold to
(100 - idle)/100.
If idle equals zero, then set the threshold to the first listed load
average.
Using the above sample output, you would set the load threshold to
(100-99.1)/100 or .009.
Run top when performance is both poor and acceptable to determine an
acceptable load level.
Redirection
Determine if sessions should be redirected and to where they are
redirected.
If redirection is disabled or the redirect request is not accepted, the
session is deferred or rejected. See the “Deferral/Rejection” section for
configuration information.
The default is to disable redirection and display the “Server Temporarily
Unavailable” web page to a deferred session.
Table 3-2 HP WebQoS Peak Configurable Parameters: Redirection
Parameter Description
Disable Do not redirect sessions. Instead, defer or reject the session.
Redirect An alternate server to which the session is redirected.
The alternate server must contain a copy of the contents of
this server (for example, a mirror site).
Enter the fully qualified domain name or IP address of the
alternate server.
If a redirected request is not accepted, it is deferred or
rejected.