HP WebQos Peak for Solaris® Concepts and Operation Guide

14 Chapter2

Installing HP WebQoS Peak

Installing HP WebQoS

You can install HP WebQoS Peak for Solaris from the HP Software Depot

web page (http://software.hp.com) or from CD.

To install HP WebQoS Peak after purchasing and downloading the

software from HP Software Depot, do the following:

1. Go to the directory in which the tar package was downloaded.

For example, type cd /tmp

2. Type tar -xvf HPWbQoSPk.tar to extract the software package.

3. As user root, type pkgadd -d /

directory

HPWbQoSPk to install the

software.

For example, if you extracted the software package in the /tmp

directory, type pkgadd -d /tmp HPWbQoSPk.

4. Type pkginfo -l HPWbQoSPk to verify the installation.

To install HP WebQoS Peak from the CD, do the following:

1. Login as user root.

2. Insert the CD and mount the CDROM drive.

If the drive does not mount automatically, use the command

mount -F hsfs -oro

device mount_point

where

device

is the

name of CDROM device and

mount_point

is the name of the

directory on which to mount the CDROM. Make sure that

mount_point

exists.

For example, type

mount -F hsfs /dev/dsk/c0t6d0 /cdrom/hpwebqospk.

3. Type pkgadd -d

mount_point

HPWbQoSPk to install the software.

For example, type pkgadd -d /cdrom/hpwebqospk HPWbQoSPk.

4. Type pkginfo -l HPWbQoSPk to verify the installation.