HP WebQoS Peak for HP-UX Concepts and Operation Guide

72 Chapter6
Configuring HP LocalDirector Controller
Configuring HP LocalDirector Controller
Go to step 4.
• If they do not match, HP LDC might have trouble in getting
the initial weight. Check the error entries in ldc.log again
and refer to “Troubleshooting the HP LD Controller” on page
69.
4. If everything looks normal, you are ready to run the snmp_test tool.
The snmp_test program tests the SNMP connectivity between the
HP LocalDirector Controller and Cisco’s Local Director. It checks if
both SNMP_get and SNMP_set are working. Before running the
program, read the README.snmp_test.
If the snmp_test runs successfully without any errors, the SNMP
connectivity between HP LocalDirector Controller and Cisco’s
LocalDirector is working. The problem may be on the Cisco side.
Refer to Cisco LocalDirector’s manuals for troubleshooting
information.
If snmp_test finds errors, record the errors and look up these errors
in “Troubleshooting the HP LD Controller” on page 69.