HP WebQoS Peak for HP-UX Concepts and Operation Guide

70 Chapter6

Conﬁguring HP LocalDirector Controller

HP LDControl Daemon

If the HP LDControl daemon dies, check for the following error messages

in the /var/opt/hpldc/ldc.log ﬁle. Complete the listed actions for the

speciﬁed messages

Table 6-4 HP LDControl Daemon Error Log Messages and Actions

Error Message Action

Cannot open ﬁle

filename

Check that the ﬁle

filename

exists and that the HP

LDControl daemon has write permission to its directory.

Server might be

down. Initial

weight set to 0.

Exiting.

1. Make sure the web server is running on the system.

Restart/Start the web server and then restart the HP LDControl

daemon.

2. Check the parameters in the ﬁle

/etc/hpldc/webstone/conf/server-list.

3. In /etc/passwd, check for the following entry:

webstone:trKI3jiXvewTw:33:1::/tmp:/sbin/sh

If this entry does not exist, add it to the ﬁle.

4. If the web server is running, make sure it is using a non-SSL

port. The HP LDControl daemon must use a non-SSL port to

generate the initial weight.

Cannot send

weight to

LocalDirector.

1. The

snmp-server host

parameter must be set on the

system running Cisco LocalDirector. Refer to Cisco

LocalDirector’s manual for more information on setting this

parameter.

2. Check that

LDHostname

is set to the system running Cisco

LocalDirector in the /etc/opt/hpldc/conf/ldc.conf

ﬁle.