HP WebQoS Peak for HP-UX Concepts and Operation Guide

Chapter 6 69

Conﬁguring HP LocalDirector Controller

Conﬁguring a System with More than One LAN Card

If the system on which you are running the web server has more than

one LAN card, you must set the

snmp-server host

and

real

parameters in Cisco LocalDirector. Do the following:

1. On the system with multiple LAN cards, run netstat -rn and check

the routing table information. Use the IP address associated with the

Cisco LocalDirector gateway to conﬁgure the

snmp-server host

parameter of Cisco LocalDirector.

2. On the system with multiple LAN cards, run

nslookup

local_hostname

and use this IP address to conﬁgure the

real

parameter of Cisco LocalDirector.

Refer to Cisco LocalDirector’s manuals for information on setting these

parameters.

Troubleshooting the HP LD Controller

General Troubleshooting

If an error occurs, check the following two log ﬁles for error messages,

causes, and recommended actions:

1. /var/opt/hpldc/ldc.log

2. /var/opt/hpldc/webstone.log

Problems Accessing the HP LD Controller

Table 6-3 Browser Error Message and Action

Error

Message

Action

Applet

ConfApplet

can’t start.

The browser that you are using to administer the system must

support JDK 1.1 in order to run HPLDC. Two browsers that

support JDK 1.1 are Netscape Navigator 4.06 and Microsoft

Internet Explorer 4.0.