HP WebQoS Peak for HP-UX Concepts and Operation Guide

Chapter 6 63

Conﬁguring HP LocalDirector Controller

Conﬁguring Cisco LocalDirector

Because HP LocalDirector Controller sends information to Cisco

LocalDirector using SNMP traps, the

snmp-server host

parameter

must be conﬁgured in the Cisco LocalDirector.

On a system managed by Cisco LocalDirector, run netstat -rn and

check the routing table information. Use the IP address associated with

the Cisco LocalDirector gateway to conﬁgure the

snmp-server host

parameter.

Refer to Cisco LocalDirector’s manuals for information on setting this

parameter and other conﬁguration information.

Conﬁguring HP LocalDirector Controller

There are two components you need to conﬁgure before using HP LDC: the

HP LDControl server and the HP LDControl daemon.

First, bring up the LDControl page by doing the following:

1. Start the HP server. Type the following:

/opt/hpldc/admserv/start-admin

2. Start a browser that supports frames, is Java-enabled, and supports

JDK 1.1.

3. Go to the URL

http://

hostname

:8282

where

hostname

is the name of the system on which you are running

the HP server.

Reload this page if you have visited it prior to this installation.

4. Enter the following administration user (server) ID and password:

User ID: hpadmin

Password: Enter the password you conﬁgured when you ran

/opt/hpldc/admserv/setup after installation.