HP WebQoS Peak for HP-UX Concepts and Operation Guide

34 Chapter4

HP WebQoS Peak for the Zeus Web Server

Conﬁguring HP WebQoS for Zeus

You must install the Zeus web server before you run the setup script. If

you re-install the Zeus web server, you must re-run the setup script.

The setup script conﬁgures and enables WebQoS for all virtual servers.

The setup script enables NSAPI and HTACCESS for each virtual server

and creates the necessary directory and conﬁguration ﬁles for NSAPI.

The Zeus NSAPI process user and group are the same as those

conﬁgured for the Zeus web server (which were conﬁgured when you

initially installed the Zeus web server).

Running the setup.zeus Script

To run the setup script, as user root, type the following:

cd /opt/webqospk

./setup.zeus [-p]

The -p option automatically conﬁgures the user (hpacadmin) and

password (hpacadmin) of the HP WebQoS Settings administration web

page for each virtual server. If the -p option is not speciﬁed, you are

prompted to enter the user and password for the HP WebQoS Settings

administration web page for each virtual server.

If you specify the -p option, HP recommends that you change the

password. Refer to “Changing the Password of the HP WebQoS Settings

Administration Web Page” in this section for more information.

While running the setup script, at the Root pathname of Zeus server

prompt, enter the Zeus home directory (the default is /usr/local/zeus).

The setup script automatically conﬁgures and enables HP WebQoS.

Default values set for all applicable conﬁguration parameters are listed

in “HP WebQoS Conﬁgurable Parameters for Zeus” on page 79.

You can also run the setup script by typing ./setup from the

/opt/webqospk directory. This script prompts you for the type of web

server (Netscape or Zeus) that you are conﬁguring.

Example

The following is an example of running the setup.zeus script. In this