HP WebQoS Peak for HP-UX Concepts and Operation Guide

20 Chapter3

HP WebQoS Peak for Netscape

Conﬁguring HP WebQoS for Netscape

You must install the Netscape Enterprise Server before you run the

setup script. If you re-install the Netscape Enterprise Server, you must

re-run the setup script.

Running the Setup Script

To run the setup script, type:

/opt/webqospk/setup.nes

At the Root pathname of Netscape server prompt, enter the

Netscape Server root directory.

The setup script will automatically conﬁgure and enable HP WebQoS.

Default values set for all applicable conﬁguration parameters are listed

in “HP WebQoS Conﬁgurable Parameters for Netscape” on page 74.

You can also run the setup script by typing ./setup from the

/opt/webqospk directory. This script prompts you for the type of web

server (Netscape or Zeus) that you are conﬁguring.

Setting the HP WebQoS Conﬁgurable Parameters for

Netscape

You can edit the conﬁguration parameters in two different ways:

• You can access the HP WebQoS Settings administration web page at

the URL http://

system_name

/hpac. Your Netscape Server must be

running to access this page. Use the system’s root user and password

to access this page.

• You can edit the conﬁguration ﬁle

/opt/ns-

server_name

server_id

/config/hpac/config.ac

Refer to “HP WebQoS Conﬁgurable Parameters for Netscape” on

page 74 for a list of the available conﬁgurable parameters for the

Netscape server.