HP WebQoS for HP-UX Release Note

HP WebQoS on HP-UX

Installing HP WebQoS

Chapter 18

Upgrade the management user interface by uninstalling and then reinstalling the interface.

You cannot use HP ServiceControl (an early version of WebQoS) on a system where you have

installed and conﬁgured HP WebQoS. If the WebQoS setup script (described in the manual

Conﬁguring HP WebQoS on HP-UX) ﬁnds HP ServiceControl, you will see the following

message: “Would you like to remove HPAdminControl now?” If you answer no, the

Setup script exits the program.

For more information on running the WebQoS setup script, refer to the manual Conﬁguring

HP WebQoS on HP-UX. After you install WebQoS, the manual is in the following location:

/opt/webqos/docs/install_config_guide.pdf

Integrating WebQoS with the BroadVision One-To-One Server

If you are using the BroadVision One-To-One Server, you must install the BroadVision server

software before installing the WebQoS software. You must also set the following parameters

in the /etc/opt/webqos/qos.conf ﬁle on this system:

ENABLE_URL_ENCODING_BV

BV_SYSTEM_NAME

BV_USER_NAME

For more information about these parameters, refer to the section

Modifying WebQoS Global Conﬁgurations” in Chapter 3 of the Conﬁguring HP WebQoS on

HP-UX manual.