HP WebQoS Administration Guide

Setup
WebQoS setup Script (UNIX)
Chapter 236
under the directory you specify.
After the script finishes, start your web server(s).
Server 3 Setup
On server3, you are running the SCI. You must identify server 1 as the
system on which the database is running. When you run the setup script
on server 3, you must provide the following information:
• Continue?
Enter y or hit Enter to continue. If you do not want to run WebQoS or
read the software license terms, enter n to exit the script now.
• Do you accept the HP Software License Terms?
If you accept the software license terms and want to continue running
the setup script, enter y. Otherwise, enter n to exit the script.
• Would you like to create the WebQoS database on this
system?
Enter n. The database has been created on server 1.
• Please configure the name of the system where the database
runs.
Enter the name of server 1.
• Enter the database password:
Enter the password for the WebQoS database on server 1. If you have
forgotten the password, you must recreate the database.
• Would you like to enable the SCO?
Enter n. You are not running the SCO on this server.
• Would you like to enable the SCI?
Enter y. You are running the SCI on this server.
• Root pathname of Netscape server.
Enter NONE. You do not want to configure any web servers.
Note that you were not asked to enter a management console password.
The password was configured when you ran the setup script on server 1
and stored in the database.