HP WebQoS Administration Guide

Setup
WebQoS setup Script (UNIX)
Chapter 230
Restarting Individual WebQoS Components
In UNIX, if you have configured parameters in the qos.conf file after
you have run the WebQoS setup script, you must restart (by stopping
and starting) specific components (the SCA, SCI, and/or SCO).
In Windows, if you have configured parameters in the qos.conf file, you
must restart specific components (the SCA, SCI, and/or SCO).
Restarting WebQoS Components (UNIX)
To restart the SCA, type the following:
/opt/webqos/bin/sca_stop
/opt/webqos/bin/sca_start
To restart the SCI, type the following:
/opt/webqos/bin/sci_stop
/opt/webqos/bin/sci_start
To restart the SCO, type the following:
/opt/webqos/bin/sco_stop
/opt/webqos/bin/sco_start
Restarting WebQoS Components (Windows)
On a Windows NT system, to restart a WebQoS component, go to the
Control Panel and select Services. Highlight the component you want to
restart (WebQoS SCA, WebQoS SCI, or WebQoS SCO), click on the Stop
button and then the Start button.
On a Windows 2000 system, to restart a WebQoS component, click on
Start -> Programs -> Administrative Tools -> Services.
Double-Click on the component you want to restart (WebQoS SCA,
WebQoS SCI, or WebQoS SCO).
WebQoS setup Script (UNIX)
This utility enables and disables the WebQoS daemons and “qosifies”
your web server. You run it after your web server is installed and after
WebQoS is installed on systems running any WebQoS component or if