HP WebQoS Administration Guide

Setup
WebQoS Configuration Files
Chapter 2 23
qos.conf
qos.conf is the WebQoS global configuration file. In UNIX, this file is
located in the /etc/opt/webqos directory. In Windows, this file is
located in <install-directory> .
On a UNIX system, configure qos.conf before running the WebQoS
setup script. If you update qos.conf after running the setup script,
individual components (for example, the web server, SCA, SCI, and/or
SCO) must be restarted for any changes to take effect (see “Restarting
WebQoS Components (UNIX)” on page 30).
On a Windows system, if you update qos.conf, individual components
(for example, the web server, SCA, SCI, and/or SCO) must be restarted
for any changes to take effect (see “Restarting WebQoS Components
(Windows)” on page 30).
The following parameters can be set:
SCA and Web Server Parameter
The following parameter affects the SCA and web server. If you change
this parameter, you must restart the SCA and web server.
• MeasurementInterval (seconds)
Default: 30
Range: 5 - 43200 (12 hours)
How often, in seconds, WebQoS collects performance measurements.
The MeasurementInterval must be an even multiple of the
MonitorInterval.
If Site Statistics Logging is enabled from the management console,
this parameter also specifies the interval at which the SCA generates
site statistics.
Web Server Parameters
The following parameters affect the web server. If you change any of
these parameters, you must restart the web server.
• EXCLUDE_FILE_EXTNS
Default: gif jpeg jpg
Range: Up to 10 extensions can be specified. Each extension can be up
to 10 characters.