Configuring HP WebQoS for HP-UX

Conﬁguring HP WebQoS

Running the WebQoS setup Script

Chapter 338

Running the WebQoS setup Script

This utility enables and disables the WebQoS daemons and web servers

with WebQoS. You run it after WebQoS is installed on systems running

the web server tier, application server tier, and on the management

system where the SCO is run.

Run the following script on any HP-UX system you are using as an

application tier or a web server tier for WebQoS:

/opt/webqos/install/setup

When you run the setup script, you must provide the following

information:

• Continue running the script?

If you do not want to run WebQoS or read the software license terms,

you can exit the script now. Otherwise, enter y to continue.

• Do you accept the HP software license terms?

If you accept the software license terms and want to continue running

the setup script, enter y. Otherwise, enter n to exit the script.

• Do you want to enable the SCO?

You must enable one SCO in your WebQoS domain in order to

conﬁgure and manage your WebQoS-enabled web servers.

• Do you want to start the qosmond daemon?

If you want to use HP OpenView IT/Operations with WebQoS, the

qosmond daemon must be started.

• Conﬁgure the management user interface password.

This is the password you use to log in to the management user

interface. There is one password for each management server.

• Select the type of web server on which you want to use WebQoS.

Choose either NES (Netscape Enterprise Server) or Zeus.

• Enter the root pathname of your web server.

This is the path to the web server you want to manage on this system.

The setup script installs WebQoS for all the web servers operating

under the directory you specify.