Configuring HP WebQoS for HP-UX

Installing and Using HP LocalDirector Controller
Configuring HP LocalDirector Controller
Chapter 6 151
Server might
bedown.Initial
weight set to 0.
Exiting.
1. Make sure the web server is running on the system.
Restart/Start the web server and then restart the HP
LDControl daemon.
2. Check the parameters in the file
/etc/hpldc/webstone/conf/server-list.
3. In /etc/passwd, check for the following entry:
webstone:trKI3jiXvewTw:33:1::/tmp:/sbin/sh
If this entry does not exist, add it to the file.
4. If the web server is running, make sure it is using a
non-SSL port. The HP LDControl daemon must use a
non-SSL port to generate the initial weight.
Cannot send
weight to
LocalDirector.
1. The snmp-server host parameter must be set on
the system running Cisco LocalDirector. Refer to Cisco
LocalDirector’smanual for moreinformation on setting
this parameter.
2. Check that LDHostname is set to the system running
Cisco LocalDirector in the
/etc/opt/hpldc/conf/ldc.conf file.
Table 6-4 HP LDControl Daemon Error Log Messages and Actions
Error
Message
Action