HP Web Jetadmin - OXPd Solution Installer in HP Web Jetadmin

1. Make sure that the device is not in the workflow.

Note: In the Install workflow created previously, if the device needing edits is in the Apply Install

Workflow group, the workflow tries to reinstall the old solution version (with the old

configuration or license parameters) while they are being changed. Remove the device

from the workflow by removing it from the Apply Install Workflow group.

2. Select the device in the All Devices list.

3. Click the Solutions tab.

4. Select the device in the Solutions tab, and then click Edit.

5. Select Unset.

6. Click Apply to selected dev ice.

7. Finish the Edit Solution wizard.

8. Ensure that the task completed successfully.

Fleet of Devices Using a Workflow

The same example as for a single device is used—the location of the configuration depot is being

changed from http://oldconfigdepot to having no configuration depot.

The example workflow has four groups:

 Apply Install Workflow

 Echo Installed

 Needs Solution

 Potential Devices

The following changes are needed to accommodate a configuration depot unset:

1. Edit the InstallEchoSolution template, updating the configuration parameters to not specify a

configuration depot. This ensures that the correct configuration parameters are applied to any

new devices added to this workflow.

2. Run an Edit solution task to unset the configuration parameters on all devices in the Echo Installed

group.

3. View the results for the task to ensure the change is applied successfully. Provide credentials for

any devices that require them.

MONITOR THE STATUS OF A SOLUTION ON A DEVICE

WITH HP WEB JETADMIN

The workflow portions of the previous section provided ways to monitor whether or not a solution is

installed. For example, in the Installing Solutions section, only devices with the solution installed

became members of the Echo Installed group.