HP Web Jetadmin 10.3 - User Guide

●
Maximum communication interval: Specify the number of hours during which no device
communication occurs. The default is 24.
●
Critical alert interval: Specify how often devices are polled for critical alerts. The default is 5
minutes.
3. To configure static polling for supplies alerts, specify the following settings:
●
Enable static polling: Select this checkbox to enable static polling for supplies alerts.
●
Polling interval: Specify the polling interval in hours.
●
Apply at % above alert threshold: Specify the percentage above the alert threshold the supply
level must reach before the supplies alerts subscription is placed in static polling.
●
Number of devices per poll: Specify the number of devices HP Web Jetadmin polls in each polling
burst.
4. Click the Apply button.
Configure the Polling Options for Supplies
Follow these steps:
1. On the top menu bar, access Tools > Options > Device Management > Device Polling > Supplies.
2. Configure the desired settings:
●
Polling interval: Specify the number of seconds during which HP Web Jetadmin sends device
requests to the network. The default is 5.
●
Time between polling intervals: Specify the number of seconds that HP Web Jetadmin remains
idle between polling intervals. The default is 10.
●
Number of devices per poll: Specify the number of devices that HP Web Jetadmin can query
concurrently. The default is 2.
HP Web Jetadmin sends device requests for the specified number of devices to the network in a
poll burst and waits for the responses. When HP Web Jetadmin receives the response packets, it
sends another burst of device requests. HP Web Jetadmin continues to send device requests until
the specified polling interval expires, and then waits until the specified number of devices per poll
is satisfied before sending new device requests.
3. Click the Apply button.
To reset all of the values to the defaults, click the Reset to Default Values button.
Devices Configuration Options
●
Manage Hidden Devices
●
Manage Blocked Devices
Configuration options for Devices help determine which devices will be displayed or not displayed in Device
Lists.
Manage Hidden Devices
If communication with a device has not occurred within a specified number of days, you can configure
HP Web Jetadmin to automatically list the device on the Hidden Devices list so that it will not show up in
other Device lists throughout the product. The number of days specified is counted starting at midnight after
the policy has been set and the device has not been communicated with.
ENWW Device Management Configuration Options 55