HP Web Jetadmin 10.3 - User Guide

Following are steps to configure this option:
1. To enable this feature, select On.
2. To disable the hold off print job feature, select Off.
Hold Off Time
This option lets you specify the default amount of time that network print jobs must wait before starting to
print if the
Hold Off Print Jobs During Copy on page 334 option is enabled. If you want to give walk-up
copying users priority over network print jobs, you should configure the
Hold Off Print Jobs During Copy
on page 334 option. HP Web Jetadmin will not start printing any network print jobs as long as a user is
interacting with the control panel. In addition, the product will wait for the amount of time that you specify
for the Hold Off Time option after a copy job finishes printing before starting to print any network print jobs.
NOTE: If the Hold Off Print Jobs During Copy on page 334 option is not enabled, HP Web Jetadmin ignores
the Hold Off Time value entered for this feature.
To specify how long HP Web Jetadmin waits before starting network print jobs, type the number of seconds
in the text box.
Interrupt Copy Jobs
This feature lets you interrupt an active copy job between complete sets to print a new copy job. This option
lets you specify if the copy job interrupt feature is enabled or disabled. If you enable the copy job interrupt
feature, users do not have to wait for large, multi-copy copy jobs to finish printing before they can print a
new copy job.
Following are steps to configure this option:
1. To enable this feature, select On.
2. To disable the interrupt copy job feature, select Off.
Device Configuration Options for Network
●
Configuration Precedence
●
Desired USB Mode
●
DHCP User Class Option (Tag 77)
●
DHCPv4 FQDN compliance with RFC 4702
●
DNS Server
●
ePrint Settings
●
Error Handling
●
HTTP Idle Timeout
●
IPP Printer Install Wizard
●
IPv4 Information
●
IPv6 Information
●
IPX - Ethernet Frame Type
●
IPX - Frame Type Token Ring
ENWW Device Configuration Options for Network 335