HP Web Jetadmin 10.3 - User Guide

1. To send the rest of a job to a different output bin, from Output Overflow Command, select Overflow
Job.
2. Select how long the printer waits from Output auto continue timeout.
3. Select the output bin from Output Overflow Bin.
4. To continue printing a job without stapling, select Staples Out Override.
5. Select how long the printer waits from the drop-down list labeled Output auto continue timeout.
Status Page Language
This option lets you specify the device personality (PCL, PostScript, Text, or HP-GL2) that the HP Jetdirect
print server uses when it sends a status page to the device. You might need to change the status page
language to accommodate a particular printing device. For example, a PostScript printer might not be able to
understand the default PCL print page that an HP Jetdirect print server sends.
NOTE: This option only affects the test page output language, not the spooled print job language.
To set the status page language, select one of the status page language options.
Stored Job Sort Order
Use this option to specify the sort order of the stored print jobs on the device. You can sort stored print jobs
by the date or the job name.
Supplies Status Messages on Control Panel
This option lets you control whether or not supplies-related status messages will be displayed on the control
panel.
To display status messages on the device’s control panel, select Show. To suppress status messages, select
Do Not Show.
Suppress Blank Pages
This option lets you specify how the printer responds when a job with blank pages is printed. Allowing the
printer to suppress printing blank pages can save you time, toner, and paper.
Following are steps to configure this option:
1. To allow printing blank pages in a print job, select No.
2. To suppress printing blank pages in a print job, select Yes.
System Setup
This option lets you configure several settings. See the steps below for more information.
Following are steps to configure this option:
1. Clearable Warnings: Control how the device tracks clearable warnings. If On is selected, a warning is
displayed until GO is pressed. If Job is selected, a warning is displayed until the end of the job in which it
was generated.
2. Show IP Address: Lets you specify whether the device IP address should be displayed along with the
Ready Message.
3. Tray Behavior:
ENWW Device Configuration Options for Device 323