HP VPN Server Appliance sa3400/sa3450 - Regulatory Information, Hardware Installation and Safety Notices

Hewlett-Packard VPN Server Appliance SA3400/3450 Regulatory Information8
Installing/Replacing Network Interface
Cards
The following topics describe how to remove and install
network interface cards (Ethernet or serial) from the HP
VPN Server Appliance SA3400/SA3450:
• Removing the Cover
• Installing/Replacing a Network Interface Card
• Closing the Cover
Safety Precautions
WARNING: Turn the power off, disconnect the power
cable, and disconnect all other cables before you perform
this procedure. Do not reattach any cables until you
replace the cover of the unit chassis and tighten the cover
screws on the chassis.
CAUTION: Attach the disposable grounding wrist strap to
your wrist and an exposed portion of the HP VPN Server
Appliance SA3400/SA3450 chassis, as indicated in the
instructions on the wrist strap packaging.
Special Considerations
The HP VPN Server Appliance SA3400/SA3450 firmware
automatically detects the type of network interface card
(Ethernet or serial) in the device. Cards can be replaced
and installed in either slot (1 or 2).
Removing the Cover
1. Loosen and remove the six cover release screws: two
screws located on the rear panel, and four screws
located on the side of the HP VPN Server Appliance
SA3400/SA3450 chassis.
2.
Remove the top cover of the HP VPN device.