HP VPN Server Appliance sa3400 - Acceleration Card Upgrade Installation Notes

Acceleration Card Upgrade Notes 3
Installing/Replacing the Encryption
Acceleration Card in the VPN Device
This section explains how to install or replace the
Encryption Acceleration card in your VPN device and
covers the following topics:
• Safety precautions
• Removing the cover of the VPN device
• Installing/replacing the Encryption Acceleration Card
• Closing and securing the cover of the VPN device
Safety Precautions
WARNING: Turn the power off, disconnect the power
cable, and disconnect all other cables before you perform
this procedure. Do not reattach any cables until you replace
the cover of the unit chassis and tighten the cover screws
on the chassis.
CAUTION: Attach the disposable grounding wrist strap to
your wrist and an exposed portion of the VPN device
chassis, as indicated in the instructions on the wrist strap
packaging.
Removing the Cover of the VPN Device
To remove the cover of the VPN Device:
1. Loosen and remove the six cover release screws
located on the sides and rear of the unit chassis.
2. Remove the top cover of the VPN device.