HP VPN Server Appliance sa3400 - Acceleration Card Upgrade Installation Notes

4 Hewlett-Packard VPN Server Appliance SA3400
Installing/Replacing the Encryption
Acceleration Card
To install or replace the encryption acceleration card:
1. Remove the screw that holds the slot cover in place in
the third slot from the left when you are looking at the
rear of the chassis from the outside of the VPN device.
2. Discard the slot cover.
3. Push the Encryption Acceleration Card into the
connector, and ensure that it is firmly seated.
4. Replace and tighten the screw back into place, so that it
firmly holds the Encryption Acceleration Card.
Closing and Securing the Cover of the VPN
Device
To replace the cover of the VPN device:
Lower the top cover of the VPN device chassis and then
slide the cover forward.
1. To ensure proper alignment, replace and tighten the
two rear screws first.
2. Replace and tighten the remaining four screws on the
sides of the unit chassis.
Reconnect all the cables, including the power cable, to the
unit chassis.