HP VPN Server Appliance sa3110/sa3150/sa3400/sa3450 Network Layout Reference Guide

HP VPN Server Appliance SA3110/SA3150/SA3400/SA3450 Network Layout Reference Guide
8 Hewlett-Packard VPN Server Appliance SA3110/SA3150/SA3400/SA3450 Network Layout Reference Guide
• For direct dial into the PSTN:
— Traffic may go through a router or remote access server,
which may or may not perform network address transla-
tion.
— The traffic then goes through the VPN device, which is
set to bridge mode. The VPN device may or may not
perform firewall functions on the traffic.
Figure: Bridge Configuration
Figure: Bridge ConfigurationFigure: Bridge Configuration
Figure: Bridge Configuration
Configuring a Bridge Configuration
Configuring a Bridge ConfigurationConfiguring a Bridge Configuration
Configuring a Bridge Configuration
When setting up a VPN device, you must configure many global
configuration You configure the VPN device through the VPN
Manager or command shell.
To set up a bridge configuration, use the configuration
parameters in the following table. Note that the values of these
parameters are examples only; you must enter values specific to
your network.
With/Without
Firewall Functions
Internet
Router
VPND
Internet Connection
Direct Dial
Desktop System
Desktop System
File Server
Laser Printer
PSTN
Router or
Remote Access Server
Bridge
Mode
Desktop System
Desktop System
E1 E0
Internal
Network B
(directly
connected
to Internet)
Internal
Network A
VPN Client