HP VMA-series Memory Array Installation and Service Guide

General Commands
HP-AM456-9002A Rev 01 VMA-series Memory Array Installation and Service Guide 215
Where:
The available commands and sublevels are different in each context level.
exit
Exits the CLI.
Syntax
exit
format
Configures the system for a specific percentage of usable flash capacity.
Note: Use this command only on a flash-based Memory Arrays.
Note: The format command will be rejected if there are any open files
accessing the memory array storage device (/dev/vtmsa). Close any open
files or unmount any mounted filesystems using the storage device. To unmount
the file system use the umount Linux command (e.g., umount /dev/vtmsa).
Syntax
format flash-capacity [
<value>]
context_level Specifies the context level to navigate to. Valid
values are:
• chassis (See Chassis Context Commands on page
221.)
• cli (See CLI Context Commands on page 245.)
• raid (See RAID Context Commands on page 251.)
• system (See System Context Commands on page
257.)