HP VMA SAN Gateway Software Update Guide

3. Wait a few minutes and reconnect to the network CLI session.
Verifying the new OE image is active after the gateway reboots
Once the gateway has completed rebooting, verify that the new gateway OE image is active.
To display the currently active OE version, issue the show version command.
The VMA SAN Gateway has been successfully updated with the gateway OE image version.
This completes the process for updating the VMA SAN Gateway using the CLI method. The following
chapter describes the same process, only using the VMA SAN Gateway web interface.
10 Using the gateway CLI and a USB flash drive