HP VMA SAN Gateway for VMA-series Memory Arrays Release Notes - August 2012 - Software OE version G5.1.0

5
Documentation location
Applicable documentation for the HP VMA SAN Gateway and VMA-series Memory Arrays can be
found at www.hp.com/go/vma-docs Some important documents for this release are listed below:
•
HP VMA SAN Gateway Installation and User Guide - AM456-9007B
•
HP VMA3205 and VMA3210 Array Firmware Update Guide - AM456-9021A
• HP VMA SAN Gateway Software Update Guide - AM456-9022A
• Configuring a Redundant Pair of VMA SAN Gateways Process Guide – AM456-9023A
Please carefully review each document fully before starting any procedure.
Setup & configuration of a standalone VMA SAN Gateway
This section gives guidance for setup and configuration of a Standalone or single VMA SAN
Gateway configuration. It can also be used for setup and configuration of the ‘primary; gateway of a
redundant VMA SAN Gateway pair. If you have an existing standalone gateway and need to add-in
a ‘secondary’ gateway to form a redundant gateway pair or if you have two standalone gateways
which you intend to pair, please go to the section below titled “Setup & configuration of a
redundant VMA SAN Gateway pair”. Additional information and details for connection and setup of
a standalone VMA SAN Gateway configuration can be found in the HP VMA-Series SAN Gateway
Installation and User Guide, document number AM456-9007B Rev 02, available at
www.hp.com/go/vma-docs.
Configuration of a standalone VMA SAN Gateway is comprised of the following steps:
1. VMA SAN Gateway Hardware Configuration
2. VMA SAN Gateway Software Configuration
3. SAN Connectivity with the VMA SAN Gateway
4. Configuring and Presenting LUNs to connected Host Servers
VMA SAN Gateway hardware configuration
The base VMA SAN Gateway, Part Number AM465A, comes with:
• Two dual port 8Gb FC adapters (acting as four storage target ports)
• Redundant (two) power supplies
• Two 146GB SAS disks configured with RAID1 mirroring
• Preloaded with the vSHARE software operating environment (OE)
HP Supports a maximum of two VMA-series Arrays connected to one VMA SAN Gateway. For a
standalone gateway configuration, each VMA-series Array requires one VMA PCIe Pass Thru Card
(P/N AM464A which must be ordered with the array) installed in the VMA SAN Gateway and one
PCIe cable connecting the VMA SAN Gateway to the VMA Array. You can mix models of VMA-series
Memory Arrays connected to the VMA SAN Gateway.