Configuring a Redundant Pair of VMA SAN Gateways - Process Guide

26
eth0 (mtu: 1500)
eth1 (mtu: 1500)
eth2 (mtu: 1500)
eth3 (mtu: 1500)
eth4 (mtu: 1500)
eth5 (mtu: 1500)
eth6 (mtu: 1500)
eth7 (mtu: 1500)
eth8 (mtu: 1500)
Global default-gateway:
Enabled: no
Global mtu:
Enabled: yes
Global VLANs:
Enabled: yes
Interfaces:
vlan14 (id: 14, if: eth0)
*hp-gateway2 [memgate-cluster: *unknown*] (config) # write memory
Configure Management VIP on Secondary Gateway
Configure the Virtual IP (VIP) which will be used for management operations of the gateway pair on
the ‘secondary’ gateway. The management VIP is a virtual IP that will route user management
operations to the active ‘master’ gateway of the redundant pair.
# cluster master address vip <IP address> /<network prefix>
# write memory
hp-gateway2 [memgate-cluster: master] (config) # cluster master address vip
10.61.184.240 /24
*hp-gateway2 [memgate-cluster: master] (config) # show network
Networking configuration:
Bonded interface eth0:
Enabled: yes
Interfaces:
eth1
eth2
Jumbo frames:
Enabled: no
Interfaces:
eth0 (mtu: 1500)
eth1 (mtu: 1500)
eth2 (mtu: 1500)
eth3 (mtu: 1500)
eth4 (mtu: 1500)
eth5 (mtu: 1500)
eth6 (mtu: 1500)
eth7 (mtu: 1500)
eth8 (mtu: 1500)
vlan14 (mtu: 1500)
Global default-gateway:
Enabled: no
Global mtu:
Enabled: yes
Global VLANs:
Enabled: yes
Interfaces:
vlan14 (id: 14, if: eth0)
*hp-gateway2 [memgate-cluster: master] (config) # show cluster global
Cluster ID: 00600-0008-7178
Cluster name: memgate-cluster
Management IP: 10.61.184.240/24
Cluster master IF: eth0
Cluster node count: 1