HP VAN SDN Controller Administrator Guide v3

Table 7 Controller settings to support hybrid mode
CommentsKeyController Configurations Component
hybrid.modecom.hp.sdn.ctl.of.impl.ControllerManager
Enable this setting if there
are switches in the network
learn.multihop.linkscom.hp.sdn.ctl.linkdisco.impl.LinkManager
that are not controlled by
the controller, but the
topology across these
switches must be visible to
the controller. That is, if any
controlled OpenFlow
switches in the same
OpenFlow instance are
separated by
non-OpenFlow switches,
use this setting.
To support controlled,
ProVision OpenFlow
arp.agecom.hp.sdn.ctl.nodemgr.impl.NodeManager
switches, change this
setting in the controller to
be greater than or equal to
the “ip arp-age” setting on
the controlled switches.
To view or reconfigure any of the above controller configuration components, click on the
component, then click on the Modify button. For more on this topic, see the "Configurations" section
in chapter 2 of this guide.
78 Hybrid mode for controlling packet-forwarding