HP Remote Graphics Software 6.0 User Guide

If set to 1, the RGS audio subsystem will be enabled. If set to 0, RGS audio will be disabled and no
network bandwidth will be consumed for Remote Audio. The default value is 1—audio is enabled.
Rgreceiver.Audio.Quality=int （1）
Rgreceiver.Audio.Quality.IsMutable=bool （1）
The audio quality property can be set to low (0), medium (1), or high (2) quality. This property is used
to adjust the sample rate of the streaming audio. Less information is sent over the network if the
sample rate is lower—and, therefore, the less network bandwidth that is consumed. The default value
is 1—medium audio quality.
Rgreceiver.Audio.IsFollowsFocusEnabled=bool （0）
Rgreceiver.Audio.IsFollowsFocusEnabled.IsMutable=bool （1）
If set to 1, enables only the audio stream associated with the Remote Display Window that currently
has the keyboard focus. The audio stream from all other active connections is disabled. Setting the
property to 0 combines the audio from all active connections into a single stream. The default value is
0—combine audio from all active connections, and play in a single stream.
Rgreceiver.Audio.IsInStereo=bool （1）
Rgreceiver.Audio.IsInStereo.IsMutable=bool （1）
If set to 1, stereo is enabled, and both the left and right channels are transmitted. The highest quality
audio (2) with stereo enabled is equivalent to CD quality audio but consumes more network
bandwidth. The default value is 1—stereo is enabled.
Receiver microphone property
Rgreceiver.Mic.IsEnabled=bool （0）
Rgreceiver.Mic.IsEnabled.IsMutable=bool （1）
If set to 1, remote microphone is enabled (on/unmuted). The default value is 0—remote microphone
is disabled (off/muted).
Receiver USB properties
Rgreceiver.Usb.IsMutable=bool （1）
If set to 1, the user can modify all USB controls in the Receiver Control Panel. If set to 0, none of the
USB controls can be changed by the user. This property can be used to permanently enable or
disable Remote USB before the RGS Receiver is started. The default value is 1—the user can modify
all USB controls.
Rgreceiver.Usb.IsEnabled=bool （1）
Rgreceiver.Usb.IsEnabled.IsMutable=bool （1）
If set to 1, Remote USB will be enabled. If set to 0, Remote USB will be disabled. The default value is
1—Remote USB is enabled.
Rgreceiver.Usb.ActiveSession=int （0）
Rgreceiver.Usb.ActiveSession.IsMutable=bool （1）
When the Receiver is in Directory Mode, the local computer can connect to one or more remote
computers. This property specifies the remote computer that the local USB devices are attached to.
To have all local USB devices attached to the first remote computer, use value zero. To have all local
RGS Receiver properties 127