HP Remote Graphics Software 6.0 User Guide

Figure 7-3 The Receiver Control Panel in Directory Mode
After clicking Connect All, you’ll need to independently authenticate and log into each remote
computer.
If Setup Mode is activated by the hotkey sequence (as opposed to the Setup Mode button), and you
have multiple Remote Display Windows on your computer, you can bring up the Remote Display
Window selection dialog to view a thumbnail image of each Remote Display Window.
Figure 7-4 Remote Display Window selection dialog
To display the selection dialog, press the TAB key while in Setup Mode—again, Setup Mode must
have been previously activated by the hotkey sequence. The selection dialog is displayed as long as
the initial Setup Mode hotkey (normally the Shift key) remains pressed. The currently-selected
Remote Display Window is highlighted with a red border.
The Remote Display Window selection dialog is only displayed in Directory Mode—this is the mode
that supports multiple Remote Display Windows. While the Remote Display Window selection dialog
is active, navigate between windows (thumbnails) by:
●
Pressing TAB to select the next window.
●
Clicking on the number displayed beneath the thumbnail.
●
Clicking directly on a thumbnail.
●
Double-clicking the mouse on a thumbnail (this will also immediately close the selection dialog).
When the initial Setup Mode hotkey is released, the selected Remote Display Window is brought
to the forefront and displayed.
Using RGS in Directory Mode 85