HP Remote Graphics Software 6.0 User Guide

Attaching a local USB device to a remote computer
Figure 7-2 Remote USB options
The Remote USB options are:
●
Enable Remote USB—This checkbox can be used to dynamically (during an active RGS
connection) enable or disable USB connections to the remote computer. When enabled, USB
devices plugged into the local computer appear to the remote computer as locally attached
devices. Because Remote USB supports hot plug connections, it is not necessary to disable
Remote USB before plugging or unplugging USB devices on the local computer.
●
Select sender—If multiple remote computers are specified in Directory Mode, the Select sender
drop down menu is used to select which remote computer (Sender) receives the Remote USB
connection. In
Figure 7-2 Remote USB options on page 73, the RGS Receiver is operating in
Directory Mode and the remote computer at IP address 10.10.42.65 is selected to receive the
Remote USB connection.
NOTE: Directory Mode operation is discussed in Using RGS in Directory Mode on page 83.
Remote USB 73