HP Remote Graphics Software 6.0 User Guide

Sender general properties
Rgsender.IsRdpLogoutDetectionEnabled=bool （1）
This property only applies to the Windows versions of the RGS Sender.
When a user disconnects from a RDC session, the Windows desktop on the remote computer is
immediately available for an RGS connection. However, if the user logs out of the RDC session, the
RGS Sender will be unable to access the desktop for about 60 seconds. If this property is set to 1, the
desktop will be available to RGS almost immediately. The RGS Sender will monitor the RDC session
for a logout, and begin the process of making the desktop available as soon as the logout is detected.
If set to 0, the RGS Sender will not monitor the RDC session for a logout. The default is 1— allow
quick access to the Windows desktop after Remote Desktop logout.
Rgsender.IsCopyRegionEnabled=bool （1）
If set to 1, RGS Copy Regions are sent from the Sender to the Receiver. If set to 0, RGS Copy
Regions are turned off and will be sent to the Receiver as Image Update Regions. This is for
advanced use and should not be set. The default value is 1—send RGS Copy Regions.
Rgsender.IsRegionLimitEnabled=bool （0）
This property is used to limit the number of update rectangles in a update region. This is for advanced
use and should not be set. The default value is 0— do not limit regions.
Rgsender.IsDisconnectOnLogoutEnabled=bool （1）
If set to 1, the RGS connection will be disconnected when the user logs out. If set to 0, the RGS
connection will remain connected to the Sender when the user logs out. The default value is 1—
always disconnect when the user logs out.
Rgsender.ImageCodec.Preferred=string （NC HP2 JPEG-LS）
Available CODECs are:
●
NC (HP3) The default since release 5.0
●
HP2 The default prior to release 5.0
●
JPEG-LS Lossless, available since 5.3.2
This property sets the preferred CODEC for encoding and decoding all image data sent from the
Sender to the Receiver. Both the Sender and Receiver must support the specified CODEC, otherwise
the connection will fall back to the lowest common CODEC. The system will automatically select the
best CODEC for normal use. For situations requiring a mathematically lossless CODEC, select
JPEG-LS. Note the JPEG-LS codec ignores the Rgreceiver.ImageCod
ec.Quality property.
Rgsender.MaxImageUpdateRate=int （30）
This property limits the number of image updates per second transmitted from the remote computer
to the local computer. The value is the maximum number of updates per second. If the image update
rate is too high, and using too much network bandwidth, the MaxImageUpdateRate can be set to limit
the number of image updates per second. The default value is 30. To specify no limit on the number
of image updates per second, set the property to 0—this is interpreted to mean that the image update
rate should not be limited.
Rgsender.IsBlankScreenAndBlockInputEnabled=bool （1）
If set to 1, this property enables monitor blanking on certain remote computers when a primary user
logs in from a local computer. This property also enables blocking of input from a keyboard and
mouse that are directly connected to the remote computer. If set to 0, monitor blanking is disabled.
RGS Sender properties 137