HP Remote Graphics Software 6.0 User Guide

If set to 1, when connecting to an RGS Sender, the user will always be prompted for the domain,
username and password. There will be no attempt to automatically verify the user credentials. The
default value is 0—prompting for credentials is off.
Rgreceiver.Directory=string （directory.txt）
Rgreceiver.Directory.IsMutable=bool （1）
Used in Directory Mode to set the name and location of the file that lists the remote computers
assigned to the current user. The default value is "directory.txt".
Rgreceiver.MaxSenderListSize=int （5）
Rgreceiver.MaxSenderListSize.IsMutable=bool （1）
In Normal Mode, the Receiver keeps a list of the Senders that it has most recently connected to.
Figure 8-3 The Receiver maintains a list of the most recently connected Senders. on page 121
shows the Receiver Control Panel dialog that this property applies to. This property specifies the
maximum number of remote computers the Receiver will keep on its list—in
Figure 8-3 The Receiver
maintains a list of the most recently connected Senders. on page 121, two remote computers
(Senders) are on the list. The Receiver will keep the most recently connected remote computers on
its list, up to the maximum number specified by this property. Minimum useful value is 1.
Figure 8-3 The Receiver maintains a list of the most recently connected Senders.
Rgreceiver.IsMatchReceiverResolutionEnabled=bool （0）
Rgreceiver.IsMatchReceiverResolutionEnabled.IsMutable=bool （1）
If this property is enabled, the local computer (Receiver) will attempt to set the resolution of the
remote computer to the same full-screen resolution of the local computer. If the local computer
display resolution is not supported by the remote computer, the connection occurs at the existing
remote computer (Sender) resolution, and a warning dialog is issued to the user. The original (pre-
modification) remote computer display resolution is restored when the RGS connection is terminated.
Rgreceiver.IsMatchReceiverPhysicalDisplaysEnabled=bool （0）
Rgreceiver.IsMatchReceiverPhysicalDisplaysEnabled.IsMutable=bool （1）
If the following conditions are met:
1. This property is enabled.
2. Rgreceiver.IsMatchReceiverResolutionEnabled is enabled (see above property).
3. Rgreceiver.Session.<N>.VirtualDisplay.IsPreferredResolutionEnabled is
disabled.
RGS Receiver properties 121