HP Remote Graphics Software 6.0 User Guide

Audio tab
The audio controls in the Receiver Control Panel are shown in Figure 6-3 Audio controls
on page 58.
Figure 6-3 Audio controls
The options available under the Audio tab are:
●
Don't stream audio from Sender—When selected, the RGS Sender will not send the audio
stream along with the video stream to the Receiver.
●
Stereo—This checkbox enables or disables stereo audio. Stereo audio sends independent audio
streams for the left and right channels but at the expense of greater network bandwidth
utilization. If this box is unchecked, monaural audio is sent by the remote computer.
●
Quality—This pull-down menu allows the local user to select one of three different audio quality
settings:
◦
Low—Specifies a sampling rate of 11 kHz.
◦
Medium—Specifies a sampling rate of 22 kHz.
◦
High—Specifies a sampling rate of 44 kHz, which is equivalent to CD quality audio.
Higher quality audio (and its higher sampling rate) requires more network bandwidth, and
can impact the performance of RGS, especially over bandwidth-constrained networks.
NOTE: For more information about Remote Audio, refer to Remote Audio on page 68.
58 Chapter 6 RGS settings