HP Remote Graphics Software 6.0 User Guide

[-h | -help | -?]—Displays the Receiver command line options that are listed on this page
-Rgreceiver.propertyname=value—Can be used to specify one or more RGS Receiver
properties. See
RGS properties on page 113 for general information on RGS properties. For
information specifically on RGS Receiver properties, see
RGS Receiver properties on page 115.
After the Receiver starts, you’ll see the Receiver Control Panel (see
Figure B-1 Receiver Control
Panel on page 149).
Figure 5-6 Receiver Control Panel
42 Chapter 5 Using RGS