Installing and Managing HP-UX Virtual Partitions (includes A.04.03)

Chapter 8
nPartition Operations
Reconfiguring an nPartition (Integrity)
220
keira2# shutdown -h
...
Transition to run-level0 is complete.
Executing "/sbin/reboot-R ".
Note: If this is a partitionable system, the requested reconfiguration will not take place until
all the virtual partitions on this hard partition are shut down and the virtual partition Monitor
is rebooted.
Shutdown at 16:19 (in 0 minutes)
This should bring you to the Monitor prompt (MON>)
4. From the Monitor prompt, boot the nPartition into nPars mode:
MON> reboot nPars
Allow the nPartition to boot into nPars mode. If autoboot is not setup, perform the boot into nPars mode
manually when the system comes up:
Shell> fsN:
fsN:\> efi\hpux\hpux /stand/vmunix
5. Once the system boots into nPars mode, the OS kernel automatically will write the correct CPU mapping
data to EFI. Now you can reboot the nPartition back into vPars mode and reboot the Monitor.
keira# vparenv -m vPars
keira# shutdown -r
...
fs0:\EFI\HPUX> boot vpmon
...