HP Superdome 2 Partitioning Administrator Guide

NOTE: The -Z option creates an nPartition from the PartitionSpec partition
specification.
• The following command modifies the alternate parspec named PartitionSpec to add
a new blade in enclosure 1 slot 3 to the nPartition definition.
parmodify -Z PartitionSpec -a blade:1/3
Removing a Partition Specification
Use the following command to remove a parspec:
parremove -Z PartitionSpec
Saving the Current Configuration of nPartition and Switch to an Alternate Configuration
To save your current configuration and switch to an alternate configuration, complete the
following steps:
1. parmodify -p 1 -c Saved_Config
2. poweroff partition 1
3. parremove -p 1
4. parcreate -Z Alt_Config
Viewing Partition Specification Using the OA GUI
To view a partition's parspec name on the OA GUI, complete the following steps:
1. Launch the OA GUI.
2. Select an nPartition.
3. Click Modify nPartition. Figure 3-2 “Viewing Partitition Specification Information” shows
the window with the Partition Specification Name.
Figure 3-2 Viewing Partitition Specification Information
28 Getting Started with nPartitions