Installing and Managing HP-UX Virtual Partitions (A.01.01)

Monitor and Shell Commands
Creating a Partition
Chapter 5 83
Creating a Partition
You can create a virtual partition using the vparcreate command.
NOTE When you create a partition, the vPars monitor assumes you will boot
and use the partition. Therefore, when a partition is created, even if it is
down and not being used, the resources assigned to it cannot be used by
any other partition.
Also, when using vPars, the physical hardware console port must be
owned by a partition. To avoid terminal type mismatches, this should be
the first partition created. For an example, see “Ensuring the Hardware
Console Port Is Owned by the First Virtual Partition” on page 57.
Example To create a partition named winona2 with the following resources:
• Three total CPUs (two bound CPUs at hardware paths 41 and 45 and
one unbound CPU) with a maximum of four (bound plus unbound)
CPUs
• 1280 MB of memory
• all hardware where the path begins with 0/8 or 1/10
• a boot disk at 0/8/0/0.5.0
use the corresponding vparcreate command line options:
Resource or Attribute vparcreate Option
partition name is winona2 -p winona2
three total CPUs -a cpu::3
of which two are bound CPUs and a
maximum of four CPUs
-a cpu:::2:4
at hardware paths 41 and 45 -a cpu:41 -a cpu:45
1280 MB of memory -a mem::1280