HP Integrity Virtual Machines Release Notes Version A.03.50

3 Creating Virtual Machines
This chapter contains notes about creating and configuring virtual machines on the VM Host
system.
3.1 Default Guest Settings for HP-UX, Windows, and Linux
Table 3-1 lists the default guest settings for HP-UX, Windows, Linux, and Unknown guests. An
Unknown guest is a virtual machine that has not booted with any operating system. When an
Unknown guest type boots, the appropriate operating system type is applied to the guest
configuration.
The following guest OS specific settings are applied if you specify the operating system type
with the -0 option to the hpvmcreate command.
Table 3-1 Guest Default Settings
Unknown Guest
Operating System
Default Settings
Linux Guest Default
Settings
Windows Guest
Default Settings
HP-UX Guest Default
Settings
4444Maximum CPUs
1111Default CPUs
2 GB2 GB2 GB2 GBDefault memory
32 MB512 MB1 GB512 MB
1
Minimum memory
128 GB64 GB64 GB64 GBMaximum memory
64 MB64 MB64 MB64 MBDefault reserved
memory
32 MB32 MB64 MB32 MBMinimum reserved
memory
128 GB64GB64 GB64 GBMaximum reserved
memory
1 The minimum memory requirement for HP-UX 11i v2 is 512 MB. The minimum memory requirement for HP-UX
11i v3 is 1 GB (see "System Requirements" section in the HP-UX 11i v3 Installation and Update Guide); however, the
HP-UX 11i v3 Installation and Update Guide warns that cold installations with 1 GB or less memory might fail or take
a long time to complete. Therefore, 2 GB is recommended for cold installations of HP-UX 11i v3.
NOTE: The amount of memory you should allocate to the guest must be sufficient to allow the
guest operating system to boot. This amount might differ from the defaults documented here.
For specific memory requirements, see the product documentation for the operating system and
applications on the guest.
3.2 Autoboot Causes Virtual Machines to Start
The virtual machine start_attr attribute can be set to auto or manual using the -b option
to the hpvmcreate, hpvmmodify, and hpvmclone commands. When this attribute is set to
auto, the virtual machine starts whenever Integrity VM starts running. This also occurs after
you install or upgrade Integrity VM.
3.3 Reserving Swap Space for Guests
Integrity VM installation requirements includes swap space for guests. Swap space on the VM
Host must be configured as device swap (not file system swap). The amount of swap space must
be no less than the total size of physical memory plus 4 Gb.
3.1 Default Guest Settings for HP-UX, Windows, and Linux 31