Administrator's Guide

Figure 49 Client console awaiting server action
Configuring the installation
To begin the installation, select a client by clicking on its icon, and then select one of the following
from the Actions menu:
— Install Client->New Install... to install a new client as described in “New installation” (page 116).
— Install Client−> Repeat Install... to use the configuration of a previously installed client as
described in “Repeat an installation” (page 145).
Figure 50 Ignite-UX Actions menu
New installation
The new installation procedure follows a linear path until the client installation configuration interface
is displayed. At that point, the amount of configuring done is at your discretion.
116 Booting and installing HP-UX on clients using the server