HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

Table 27 Troubleshooting EVWEB (continued)
SolutionCauseProblem
indicate a problem with
the installation
To disable EMS logging events to syslog, complete the following
steps:
The syslog functionality
is available from
Both EMS and
SysFaultMgmt (System
SysFaultMgmt (SystemFault Management) (SFM)
1. Delete the monitoring request using monconfig. Enter the
following command to delete the monitoring request:
# /etc/opt/resmon/lbin/monconfig
Fault Management)
(SFM) Version
C.06.00.07.01,
log the same symptom in
the syslog.
September 2009
2. Select the delete option to delete the request.
(D)elete a monitoring request
release, to provide a
summary of event
3. The current monitor configuration is:
1) Send events generated by all monitors
with severity >= MAJOR WARNING to SYSLOG
information of critical
and serious events. The
default subscription to
syslog
2) Send events generated by all monitors
with severity >= INFORMATION to TEXTLOG
HP_defaultSyslog is
/var/opt/resmon/log/event.log
configured. When events
3) Send events generated by all monitors
with major or critical
with severity >= MAJOR WARNING to EMAIL root
levels are detected at
SysFaultMgmt (System
4) Send events generated by monitors
/storage/events/disks/default
Fault Management)
with severity > CRITICAL to SNMP
(SFM) diag mode, an
5) Send events generated by monitors
event is sent to the EMS
/storage/events/disks/default
framework through the
with severity > MAJOR WARNING to SNMP
WBEM Wrapper
6) Send events generated by monitors
Monitor or the EMS
/system/events/ipmi_fpl
with severity = CRITICAL to SNMP
Wrapper Monitor. EMS
with comment:
is configured to log
no
events with Major
7) Send events generated by monitors
Warning, Serious or
/system/events/memory_ia64
Critical severity levels to
/system/events/system_status
with severity = CRITICAL to SNMP
the syslog. Even after
switching to the EMS
Enter number of monitoring request to delete
{(Q)uit,(H)elp} 1
mode, the same
behavior occurs.
4. Enter 1 to delete events with MAJOR WARNING severity.
5. To disable the email facility from EMS, delete the following
monitoring request using monconfig:
3) Send events generated by all monitors
with severity >= MAJOR WARNING to EMAIL
root
Install HP Operations Manager Software for UNIX agent (HTTPS)
on HP-UX. Configure a policy used by HTTPS agent to monitor
WBEM indications logged in syslog as follows:
SysFaultMgmt (System
Fault Management)
(SFM) does not provide
The OpCmsg notification
is not available in
SysFaultMgmt (System
Fault Management) (SFM)
MMM DD HH:MM:SS xxxxx CIM Indication (default
format):ProviderName =
the same functionality as
EMS
SEL02_IndicationProvider, PerceivedSeverity =
2, EventID = 103
MMM DD HH:MM:SS xxxxx CIM Indication (default
format):EventID = 8, PerceivedSeverity = 2,
ProviderName = StateChangeIndicationProvider
For more information, see the HP Operations Manager Software
for UNIX documentation.
For the property order logged in syslog, see “ Syslog property
order” (page 128)
Troubleshooting EVWEB 97