HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

5. Click OK on the confirmation message window.
For more information about modifying tracing using the HP SMH GUI, select Help on the action
pane of the Modify Tracing page.
Modifying Tracing using the EMT CLI
To modify tracing using the EMT CLI, enter the following command at the HP-UX prompt:
# export EMT_TRACE_LEVEL=<new trace value>
Tracing is now modified. The new trace value is the trace level that you want to set.
Disabling Tracing using the EMT GUI
To disable tracing using the HP SMH GUI, complete the following steps:
1. Repeat steps 1-5 from “Launching EMT” (page 76).
NOTE: The Disable Tracing option is not displayed if tracing is not enabled.
2. Select Disable Tracing on the top right corner of the Simple Search page.
The tracing is disabled and a confirmation message is displayed.
3. Click OK on the confirmation message window.
For more information about disabling tracing using the HP SMH GUI, select Help on the action
pane of the Disable Tracing page.
Disabling Tracing using the EMT CLI
To disable tracing using the EMT CLI, you must reset the trace value. To reset the trace value, enter
the following command at the HP-UX prompt:
# unset EMT_TRACE_LEVEL
Tracing is now disabled.
NOTE: Tracing is automatically disabled at the end of an EMT session.
Tracing EMT 83